Valve Guide Machining Tools Crane Cams valve guide machining tools are used to machine the valve guide OD for Crane Teflon® valve stem seals. These shop quality cutters can be used for full size aftermarket guides.
TEC	Crane	Description
87089	99018-1	1948-84 Harley-Davidson® 61-80 cu. in., cuts 3/8” valve guides to .531” OD. (arbor included)
87089	99016-1	1984-up Harley-Davidson® EVO® 80 cu. in., cuts 5/16 valve guides to .531” OD. (arbor included)

Cam Installation Tool

TEC	Crane	Description
		The Crane Cams cam installation tool will hold all of the tappets while you remove and reinstall the camshaft. This will prevent the tappets from falling out of the tappet blocks.
83361	9-0020

Oil Pump Pressure Relief Spring

Harley-Davidson® engines operate at extremely low oil pressure, both while at idle and during upper RPM operation. This premium quality, steel alloy, heat set oil pump pressure relief spring actually increases engine oil pressure by 2-3 psi and does not interfere with critical bearing lubrication needs. This added oil pressure is necessary when using aftermarket cams and valve train components and is highly recommended for extended engine life.

TEC	Crane	Description
		1966-98 Big-Twin®, including Evolution®
83362	7-0200

TDC Piston Stops

TEC	Crane	Description
		14 MM TDC Piston Stop Top dead center piston stop. This tool is used for finding “true” top dead center. The experienced engine builder uses this tool for degreeing the camshaft and marking the flywheels for the most accurate cam and ignition timing.
83359	99412-1
83358	99410-1	12MM TDC Piston Stop for Twin-Cam 88®

Spring Seat Machining Tools

These valve spring seat machining tools will let you lower the spring seat for high lift cams. All of our machining tools are job shop quality.

TEC	Crane	Description
		1948-84 Harley-Davidson® 61-80 cu. in., cuts spring seats to 1.630” OD, .635” ID (99028-1 arbor required)
99411	99405-1